QUESTION 81
What information does a router running a link-state protocol use to build and maintain its topological database? (Choose two.)
A. hello packets
B. SAP messages sent by other routers
C. LSAs from other routers
D. beacons received on point-to-point links
E. routing tables received from other link-state routers
F. TTL packets from designated routers
Answer: AC
QUESTION 82
Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)
A. Router(config)# router ospf 0
B. Router(config)# router ospf 1
C. Router(config)# router ospf area 0
D. Router(config-router)# network 192.168.16.0 0.0.0.255 0
E. Router(config-router)# network 192.168.16.0 0.0.0.255 area 0
F. Router(config-router)# network 192.168.16.0 255.255.255.0 area 0
Answer: BE
QUESTION 83
Which type of EIGRP route entry describes a feasible successor?
A. a backup route, stored in the routing table
B. a primary route, stored in the routing table
C. a backup route, stored in the topology table
D. a primary route, stored in the topology table
Answer: C
QUESTION 84
Drag and Drop Question
Drag each description on the left to the appropriate term on the right. Not all the descriptions are used.
Answer: 
QUESTION 85
Drag and Drop Question
Drag the term on the left to its definition on the right (Not all options are used.)
Answer: 
QUESTION 86
Drag and Drop Question
Drat the description on the left to the routing protocol on the right. (Not all options are used.)
Answer: 
QUESTION 87
Drag and Drop Question
Drat the Frame Relay acronym on the left to match its definition on the right. (Not all acronyms are used)
Answer: 
QUESTION 88
Hotspot Question
OSPF is configured using default classful addressing. With all routers and interfaces operational, how many networks will be in the routing table of R1 that are indicated to be learned by OSPF?
A. 2
B. 3
C. 4
D. 5
E. 6
F. 7
Answer: C
QUESTION 89
Hotspot Question
After the network has converged, what type of messaging, if any, occurs between R3 and R4?
A. No messages are exchanged.
B. Hellos are sent every 10 seconds.
C. The full database from each router is sent every 30 seconds.
D. The routing table from each router is sent every 60 seconds.
Answer: B
QUESTION 90
Hotspot Question
To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands could be used in R2? (Choose two.)
A. R2(config-if)#clock rate
B. R2(config-if)#bandwidth
C. R2(config-if)#ip ospf cost
D. R2(config-if)#ip ospf priority
E. R2(config-router)#distance ospf
Answer: BC
Latest Exam Questions for Cisco 200-101 Test — Free 200-101 Dumps Download
